王中王资料精选大全

惠州市惠阳大地消防设备有限公司

Gas fire extinguishing, superfine dry powder

National Service Hotline 13536297119
0752-3699911
18927322026

消防安全设备
You are here: 王中王资料精选大全 » Dadi Fire Information Center » Fire Information » Heptafluoropropane fire storage device pressure gauge no display solution

No display solution for pressure gauge of heptafluoropropane fire extinguishing storage device

责任编辑: 人气: - 发表时间:2019-12-12 16:11【 Article source: Editor-in-chief: Popularity : -Published time: 2019-12-12 16:11 [Large Middle Small]

If the pressure gauge of 100L2.5MPA cabinet heptafluoropropane fire extinguishing storage device is not displayed, check the following three steps:


l Check whether the pressure gauge switch of the storage device has been turned on;


l If the pressure gauge switch has been turned on and the pressure gauge still has no pressure display, the pressure gauge may be damaged. To replace the pressure gauge: Close the pressure gauge switch, remove the pressure gauge, replace the pressure gauge of the same model, and turn on the pressure gauge switch.


l If there is no pressure display after opening the pressure gauge switch after replacing the intact pressure gauge, it may be that the pressurized gas has leaked. You need to make up the pressure as soon as possible or call our company for consultation, and repair it if necessary.


100L2.5MPA cabinet type heptafluoropropane fire extinguishing. Do daily inspection and maintenance to ensure that the fire extinguishing system is in normal automatic working state and respond to fire in the protective area.


relevant information